INSTALLATION & OPERATING GUIDEBUNN-O-MATIC CORPORATION POST OFFICE BOX 3227SPRINGFIELD, ILLINOIS 62708-3227PHONE: (217) 529-6601 FAX: (217) 529
10PROGRAMMING - H5-E, H5-PC, H5X, H10X When power is applied to the dispenser, the display located on the bottom of the main circuit board will show
11PROGRAMMING - H5-E, H5-PC, H5X, H10X ContinuedLEVEL 2 PROGRAMMINGH1 - DISPENSE TEMPERATURE LOCKOUT - PORTION CONTROL ONLY(WILL NOT DISPLAY ON OTHER
Program lockout switch:The switch must be in the “SET” position in order to access the program modes.1. Disconnect the dispenser from the power sourc
132. The display will now show the model number. (H5H) 5 Gallon High Voltage Unit (200-240V) (H5L) 5 Gallon Low Voltage Unit (100-120V) Now scroll
14LEVEL 2 PROGRAMMINGH2 - F° OR C° SELECTION1. To enter Level 2 Programming, press and hold the upper hidden button until H2 appears on the display.
15TEMPREADYENERGY SAVER MODEON OFFHEATER46819.1 070215Program lockout switch:The switch must be in the “SET” position in order to access
1646819.1 0702151. Press and release the hidden button. The display will show P1. Display will now show the “SET” temperature. Press the (+) button t
17LEVEL 2 PROGRAMMINGH1 - DISPENSE LOCKOUT1. To enter Level 2 Programming, press and hold the hidden button until H1 ap-pears on the display. Release
18DRAINING THE DISPENSER- OHWCAUTION - The dispenser must be disconnected from the power source throughout these steps.1. Disconnect the dispenser fr
246819.1 031314BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTYBunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:1) Airpots, therma
3CONTENTS46819.1 070215INTRODUCTIONThis equipment heats and dispenses water on demand for beverages and cooking purposes. It has a panel above the fa
4CE REQUIREMENTS• This appliance must be installed in locations where it can be overseen by trained personnel.• For proper operation, this appliance m
5USER NOTICESThe notices on this dispenser should be kept in good condition. Replace unreadable or damaged labels.00656.0001As directed in the Intern
6ELECTRICAL REQUIREMENTSWARNING - The dispenser must be disconnected from the power source until specified in Initial Set-Up.Refer to Data Plate on the
7INITIAL SET-UP - H5E, H5X, H5-PC, H10X, H3/5 ElementCAUTION - The dispenser must be disconnected from the power source throughout the initial set-up,
INITIAL SET-UP - H5MCAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except when specified in the inst
OPERATING CONTROLS - H5 PORTION CONTROL ONLY(a) VOLUME SELECTOR BUTTONS Press and release the button corre-sponding to the Small, Medium, or Large vo
Comments to this Manuals